JVC UX-P30 Series Service Manual page 12

3.1.6 Removing the main board / heat sink
(See Fig.11 to 13)
• Prior to performing the following procedure, remove the metal
cover, the rear cover, the CD mechanism assembly and the
rear panel.
(1) Disconnect the card wire from connector CN900,
and CN931 on the main board.
(2) Disconnect the wire from
(3) Remove the two screws H attaching the main board to the
chassis on the left side ofthe body and disengage the two
joints c.
(4) Remove the two screws J attaching the heat sink to the
main board.
1-12 (No.MB049)
CN901
CN906 and CN907 respectively.
CN931
Fig.11
Main board
H
Joint c
Fig.12
Main board
Fig.13
CN901
CN900
Main board
CN906
CN907
Front panel assembly
H
Heat sink
J