Troubleshooting - Husqvarna 545FR Operator's Manual

• If you operate the product in snow or below 5°C/
41°F, attach a cover on top of the starter.
CAUTION: Do not operate the product at
temperatures of more than 5°C/41°F if it is
adjusted for winter mode. The engine
becomes too hot and can be damaged.
Make sure that the winter mode adjustments
are removed before you operate the product
at temperatures more than 5°C/41°F.
To lubricate the wire
545FXT
Note: The wire is lubricated at the factory. Lubricate the
wire when it is necessary.
The engine does not start
Check
Stop switch.
Starter pawls.
Fuel tank.
Carburetor
1018 - 004 - 06.02.2020
1. Remove the protective cover.
2. Remove the cylinder cover to get access to the
3. Make sure that the rubber bellows does not expand.
4. Remove the plug on the grease nipple.
5. Use antifreeze spray with a 2 mm spray tube. Spray
6. Attach the cylinder cover and the protective cover.

Troubleshooting

Possible cause
The stop switch is in the stop posi-
tion.
The starter pawls cannot move free-
ly.
Incorrect fuel type.
Incorrect adjustment of the idle
speed
rubber bellows on the wire.
with short intervals.
Procedure
Let an approved servicing dealer re-
place the stop switch.
Remove the starter cover and clean
around the starter pawls. Refer to
clean the cooling system and starter
pawls on page 23 .
Let an approved servicing dealer
help you.
Drain the fuel tank and fill with cor-
rect fuel.
Adjust the idle speed with the idle
speed screw T.
To
27