Wheel Removal; Wheel Installation - Linhai HY740STL 2018 Service Manual

CHAPTER 2 MAINTENANCE
2.6 WHEELS
Inspect all wheels for runout of damage.
Check wheel nuts and ensure they are tight.
Do not over tighten the wheel nuts.
WHEEL, HUB TORQUE TABLE
Item
Front Wheel Nuts
Rear Wheel Nuts
Front Spindle Nut
Rear Hub
Retaining Nut

WHEEL REMOVAL

1. Stop the engine, place the transmission in
gear
And lock the parking brake.
2. Loosen the wheel nuts slightly.
3. Elevate the side of the vehicle by placing
a suitable stand under the footrest frame.
4. Remove the wheel nuts and remove the
wheel.

WHEEL INSTALLATION

1. With the transmission in gear and the
parking Brake locked, place the wheel in
the correct Position on the wheel hub. Be
sure the valve stem is toward the outside
and rotation arrows on the tire point
toward rotation.
2. Attach the wheel nuts and finger tighten
them.
Install as shown at right for front or rear
wheels.
3. Lower the vehicle to the ground.
4. Securely tighten the wheel nuts to the
proper Torque listed in the table above.
On rear wheel nuts, Make sure tapered
end of nut goes into taper on wheel.
69 Ft.Lbs 96 N.m
69 Ft.Lbs 96 N.m
Refer to FRONT HUB
INSTALLATION
80 Ft.Lbs 110.6 N.m
M750L SERVICE MANUA 18.0
CAUTION:
If wheels are improperly installed it could
affect Vehicle handling and tire wear.
CHAPTER 2 MAINTENANCE PAGE. 2- 15