Lift Lever; Brake Pedal - Cadet AutoDrive 1600 Operator's Manual

LIFT LEVER

The lift lever is used to change the operating position
(height) of the cutting deck. To operate, move the
lever to the left, then place in the notch best suited
for your application.
PTO (POWER TAKE-OFF) LEVER
The PTO lever is located on the left side of the
dashboard next to the steering wheel. Move the PTO
lever forward to engage the power to the cutting
deck or other attachments; move the PTO lever
backward (toward the rear of the tractor) to
disengage the power to the attachments.
NOTE:
T he PTO lever must be in the disengaged
(OFF) position when starting the engine, when
shifting into reverse and if the operator leaves the
seat.
AUTODRIVE PEDAL
™
The AutoDrive pedal is located below the brake
™
pedal on the right front side of the tractor along the
running board. Depress the AutoDrive
your right foot when the tractor shift lever is in either
forward or reverse to cause the tractor to move.
Ground speed is also controlled with the AutoDrive
pedal. The further down the pedal is depressed, the
faster the tractor will travel. The pedal will return to
its original position when it's not depressed.
IMPORTANT:
Always set the parking brake
when leaving the tractor unattended.

BRAKE PEDAL

The brake pedal is located on the right front side of
the tractor above the AutoDrive
running board. The brake pedal can be used for
sudden stops or setting the parking brake.
NOTE:
activate the safety interlock switch when starting the
.
tractor
PARKING BRAKE BUTTON
To set the parking brake, fully depress
the brake pedal and push the parking
brake button in. Hold the button in
while taking your foot off the brake
pedal. Both the parking button and
the brake
depressed. To release the parking
brake,
slightly. The parking brake button will
then return to its original position.
NOTE:
operator leaves the seat with the engine running or
the engine will automatically shut off.
IMPORTANT:
when leaving the tractor unattended.
SHIFT LEVER
The shift lever is located
on the left side of the
fender
positions,
NEUTRAL and REVERSE.
The brake pedal must be
depressed and the tractor
pedal with
™
must not be in motion
when
lever.
™
IMPORTANT:
force the shift lever. Doing
so may result in serious
damage to the tractor's
transmission.
10
BRAKE
The brake pedal must be fully depressed to
pedal will then
depress the brake
The parking brake must be set if the
Always set the parking brake
and has three
FORWARD,
the moving shift
Never
pedal along the
™
P
stay
pedal
F
N
Shift
Knob
R