Page 1
In the State of California the above is required by law (Section 4442 of the California Public Resources Code). Other states may have similar laws. Federal laws apply on federal lands. A spark arrester for the muffler is available through your Cub Cadet dealer or con- tact the service department, P.O.
(Model Number) (Serial Number) Copy the model number here: Copy the serial number here: CUB CADET CORP. P.O. BOX 368023 CLEVELAND, OHIO 44136 CALLING CUSTOMER SUPPORT If you have difficulty assembling this product or have any questions regarding the controls, operation or maintenance of this unit, please call the Customer Dealer Referral Line.
SECTION 1: IMPORTANT SAFE OPERATION PRACTICES WARNING: This symbol points out important safety instructions which, if not followed, could endanger the personal safety and/or property of yourself and others. Read and follow all instructions in this manual before attempting to operate this machine. Failure to comply with these instructions may result in personal injury.
Page 4
Contact an a speeding may cause the operator to lose control of Cub Cadet dealer for assistance. the machine resulting in serious injury or death. 7. Do not tow heavy pull behind attachments (e.g.
Page 5
Gasoline is frame, your unit should be serviced professionally extremely flammable and the vapors are explosive. by a Cub Cadet dealer. Serious personal injury can occur when gasoline is 4. Check brake operation frequently as it is subjected spilled on yourself or your clothes which can ignite.
Page 6
8. Never tamper with the safety interlock system or For safety protection, frequently check components other safety devices. Check their proper operation and replace immediately with original equipment regularly. manufacturer’s (O.E.M.) parts only, listed in this 9. After striking a foreign object, stop the engine, manual.
SECTION 3: TRACTOR SET-UP Attaching the Battery Cables Service the engine with gasoline and oil as instructed in the separate Briggs & Stratton Operator/Owner Manual packed with your tractor. Read instructions carefully. NOTE: The positive battery terminal is marked Pos. (+).
SECTION 4: KNOW YOUR LAWN TRACTOR NOTE: Steering Wheel not shown for clarity. Figure 3 PTO (Power Take-off) Knob Cruise Control Button Choke Control Ignition Switch Parking Brake Button Brake Pedal Shift Lever Drive Pedal Cup Holder Deck Lift Lever Systems Indicator Monitor/Hour Meter M Seat Adjustment Lever G Throttle Control Lever...
Page 10
Refer to Operating The Headlights on page 15 activates the engine’s choke of this manual for detailed instructions. control. On model 1180, the choke control can be found on Drive Pedal the left side of the dash panel and...
Page 11
To adjust the seat forward or backward, slide the seat Cub Cadet dealer. adjustment lever to the left and reposition the seat to The hour meter operates whenever the engine is the desired position.
• DO NOT MOW WHEN CHILDREN OR OTHERS ARE AROUND. Contact a Cub Cadet dealer. The safety interlock • NEVER CARRY CHILDREN, EVEN WITH BLADES OFF. • LOOK DOWN AND BEHIND BEFORE AND WHILE BACKING.
Page 13
Driving The Tractor WARNING: Keep hands and feet away from the discharge opening of the cutting WARNING: deck. Avoid sudden starts, ex- cessive speed and sudden stops. NOTE: The deck wheels are an anti-scalp feature of the deck and are not designed to support the weight of WARNING: Do not leave the seat of the the cutting deck.
Page 14
If the operator should attempt to do so, the tractor will automatically This tractor is equipped with one of Cub Cadet’s high decelerate to the fastest optimal mowing ground speed. quality cutting decks. The following information will be helpful when using the cutting deck with your tractor.
• Keep the blades sharp and replace the blades when worn. Refer to Cutting Blades on page 18 of this Carriage Screw manual for proper blade sharpening instructions. Mulching Model 1170 lawn tractors come equipped with a mulch kit which incorporates special blades, already standard on your tractor, in a process of recirculating grass clippings repeatedly beneath the cutting deck.
Page 16
Lock Nuts Deck Stabilizer Bracket Deck Nuts Adjustment Gear FRONT TO REAR SIDE TO SIDE Hex Cap Screw Figure 10 Seat Adjustment • Determine the approximate distance necessary for proper adjustment and proceed, if necessary, to the next step. WARNING: Before operating this machine, •...
Hex Nut Hex Nut and Grease Fitting Pivot Bar Lock Washer Axle Set Gap at .011" Drag Link Brake Disc Compression Spring Jam Nut Transmission Ball Joint NOTE: View shown from beneath tractor. Figure 11 Figure 12 NOTE: Threading the ball joints too far onto the drag Steering Adjustment links will cause the front tires to "toe-in"...
Pivot Points & Linkage (approximately 48 oz. in model 1170 and 64 oz. in Lubricate all the pivot points on the drive system, model 1180). parking brake and lift linkage at least once a season • Push the oil drain valve in slightly, then rotate with light oil.
Page 19
Periodically inspect the blade WARNING: Blade Separation adapter and/or spindle for cracks or damage, especially if you strike a foreign object. Replace immediately if damaged The blades may be removed as follows. • Remove the deck from beneath the tractor, (refer to Cutting Deck Removal on page 20) then gently flip the Worn Blade Edge deck over to expose its underside.
Page 20
Fuse • Rotate the pin slightly toward the rear of the tractor and release the pin into the hole provided. A fuse is installed in your tractor’s wiring harness to • Repeat the above steps on the tractor’s right side. protect the tractor’s electrical system from damage •...
Page 21
(beneath belt guard) Deck Idler Pulley Center Pulley Self-Tapping Screws NOTE: Left hand belt cover not shown for clarity. Figure 17 Model 1180 Electric PTO Clutch PTO Idler Bracket (mounted on tractor) Deck belt (Bottom) Deck Idler Pulley PTO belt (Top)
Page 22
POSITIVE (Red) wire. Re-install in determine if you feel you could successfully complete it. reverse order. If you don’t, see a Cub Cadet dealer to have the belt changed. Upper Drive Belt •...
• Remove the hex bolt from the center of the electric PTO clutch and gently lower it off of the engine Double-idler crankshaft. Be careful not to lose any washers or Bracket spacers which may be found on top of the engine pulley.
Uneven tire pressure. Check tire pressure in all four tires. SECTION 11: ATTACHMENTS & ACCESSORIES The following attachments and accessories are compatible for Lawn Tractor Models 1170 & 1180. See the your Cub Cadet dealer for information regarding price and availability. NOTE: Lawn tractor models 1170 and 1180 are NOT designed for use with any type of ground-engaging attachments (e.g.
Page 42
Models 1170 & 1180 (for choke) Briggs & Stratton Industrial Plus Twin (for throttle) (deflector must face forward) Briggs & Stratton Industrial Plus Single (deflector must face forward)
Page 43
Models 1170 & 1180 REF. PART DESCRIPTION 710-0227 Self-tapping Screw, #8-18 x .5 710-0599 Self-tapping Screw, 1/4-20 x .5 710-0604A Self-tapping Screw, 5/16-18 x .625 710-1237 Screw, #10-32 x .625 710-1314 Socket Cap Screw, 5/16-18 x .625 710-1315 Self-tapping Screw, 3/8-16 x 1.25...
Page 44
MANUFACTURER’S LIMITED WARRANTY FOR: c. Log splitter pumps, valves and cylinders have a sepa- The limited warranty set forth below is given by Cub Cadet rate one year warranty. Corp. with respect to new merchandise purchased and d. Cub Cadet Corp. does not extend any warranty for used in the United States, its possessions and territories.