Attaching The Shoulder Strap; Wheel Assembly; Height Adjustment - Weed Eater Twist 'N Edge 545186757 Instruction Manual

Motor Housing
Cutting Head
2. Align the installation arrow on the shield
with the installation arrow on the motor
housing as shown.
Installation
arrows
3. Twist the shield as illustrated until it snaps
securely into place. Make sure the shield
is assembled to the unit as shown in the
illustration below and in the KNOW
YOUR TRIMMER section of this manual.

WHEEL ASSEMBLY

1. Fit the two halves of the wheel together
(see illustration).
Wheel
2. Attach the wheel to the trimmer. Make
sure the wheel is fitted into the groove on
Line Limiter
the motor housing.
Pin
Motor
Housing
Shield
3. Clip the wheel together securely on the
other side. The wheel should turn freely.
INSTALLATION OF ASSIST HANDLE
1. Press the two buttons on the sides of the
switch handle.
Button
Assist Handle
2. Push the assist handle over the buttons
and release the buttons.
3. Adjust the handle to the most comfortable
operating position by pressing the buttons
and moving the handle.
ATTACHING THE SHOULDER
STRAP
1. Fasten the shoulder strap hook to the re-
tainer on the switch handle.
Shoulder
Strap Hook
2. Adjust as required to ensure the shoulder
strap is in the most comfortable position.

HEIGHT ADJUSTMENT

1. Turn height adjuster in the direction indi-
cated to unlock (see illustration).
6
Groove
Button
Retainer