Channel Information - Baofeng BF-UV5R Programming Manual

3) You will come to the parameter page and adjust the limited parameters
(Channel, Band, RX Frequency, TX Frequency, CTCSS/DCS, Power, and
Wide/Narrow, PTT-ID, etc).

Channel Information

The UV5R radio has 128 channels, you can edit the channel number and channel information
according to your needs. The following is an introduction to each term.
Name Meaning
RX Freq Receiving frequency
TX Freq Transmitting frequency
RX Receiving CTCSS/DCS
QT/DQT
TX Transmitting CTCSS/DCS
QT/DQT
POWER Transmit power
W/N Channel bandwidth
PTT-ID When to send the PTT-ID
Setting
VHF:136-174MHz
UHF:400-520MHz
VHF:136-174MHz
UHF:400-520MHz
Refer to the DCS table and
CTCSS table in the manual.
Refer to the DCS table and
CTCSS table in the manual.
HIGH/LOW
WIDE/NARROW
OFF does not send
code;
BOT press PTT button to
send code;
EOT release PTT
button to send code;
BOTH press and
release PTT button to
send code
6
Description
Mutes the speaker of the
transceiver in the absence of a
specific low level digital signal. If
the station you are listening to
does not transmit this specific
signal,you will not hear anything.
Transmits a specific
digital signal to unlock the squelch
of a distant receiver (usually a
repeater).
High power:5W
Low power:1W
Wideband (25kHz bandwidth)
narrowband (12.5 kHz bandwidth).
Codes are sent during either the
beginning or end of a transmission.
low-level