Battery Disposal Warning - Weed Eater 952711899 Instruction Manual

USER REPLACEABLE SERVICE PARTS
REPLACEMENT PART
Battery Pack
Charger
WARNING:
Perform the following
steps after each use.
Stop the unit and remove the battery pack
S
when not in use.
Carry the unit with motor stopped.
S
Store the unit so the blades cannot cause
S
injury.
Store unit indoors in a high, dry place out of
S
the reach of children.
Store unit with all guards in place. Position
S
unit so that any sharp object cannot acci-
dentally cause injury.
BATTERY DISPOSAL
WARNING:
Remove the battery pack
from the hedge trimmer. Cover the terminals
with heavy duty adhesive tape. Do not attempt
to destroy or disassemble battery pack or re-
move any of its components. Nickel- -cadmium
batteries must be recycled or disposed of prop-
erly. Also, never touch both terminals with metal
objects and/or body parts to avoid short circuit-
ing the battery pack. Keep away from children.
Failure to comply with these warnings could re-
sult in fire or serious personal injury.
TROUBLESHOOTING TABLE
WARNING:
Always stop unit and remove battery pack before performing all of the
recommended remedies below except remedies that require unit to be operating.
TROUBLE CAUSE
1. Battery not attached to
Unit fails to
unit correctly.
operate
2. Battery needs charging.
3. Debris stopping blade.
Cutting blades 1. Forcing blade into
stop under a material being cut.
load or do not 2. Blades clogged with
move when debris.
trigger switch 3. Battery needs charging.
4. None of the above
is pressed
Poor cutting 1. Unit is being used
incorrectly.
quality
2. Blades clogged with
debris.
3. Damaged blades.
Excessive
1. Damaged blades.
vibration
PART NUMBER
545124416
545124415
STORAGE
To preserve natural resources, please re-
S
cycle or dispose of batteries properly.
This product contains nickel- -cadmium batter-
S
ies. Local, state or federal laws may prohibit
disposal of nickel- -cadmium batteries in ordi-
nary trash.
Consult your local waste authority for infor-
S
mation regarding available recycling and/or
disposal options.
REMEDY
1. Remove battery and check connectors.
Replace battery.
2. Charge battery pack.
3. Remove debris.
1. Cut at a slower pace.
2. Clean debris from blades.
3. Charge battery pack.
4. Contact your authorized service dealer.
1. Ensure the product is being used
correctly.
2. Clean debris from blades.
3. Contact your authorized service dealer.
1. Contact your authorized service dealer.
9