Adjusting The Handle - Weed Eater 545186796 Instruction Manual

WARNING:
If received assembled,
repeat all steps to ensure your unit is properly
assembled and all fasteners are secure.
Examine parts for damage. Do not use dam-
aged parts.
NOTE:
If you need assistance or find parts
missing or damaged, call 1-800-554-6723.
It is normal for the fuel filter to rattle in the
empty fuel tank.
Finding fuel or oil residue on muffler is normal
due to carburetor adjustments and testing
done by the manufacturer.
SHAFT ASSEMBLY
CAUTION:
When assembling shaft, place
the unit on a flat surface for stability.
1. Align grooves on upper and lower shafts.
Upper Shaft
Grooves
Lower Shaft
2. Push the two shafts together until the lower
shaft is fully seated in the upper shaft (the
shafts lock into place).
3. Slide lower locking sleeve assembly over
upper locking sleeve assembly and tight-
en by turning clockwise.
Upper Locking
Sleeve Assembly
Lower Locking
Sleeve Assembly
ASSEMBLY
NOTE:
If locking sleeve assembly will not
tighten, the shafts are not fully seated.

ADJUSTING THE HANDLE

WARNING:
handle, be sure it remains above the safety label
and below the mark or arrow on the shaft.
1. Loosen wing nut on handle.
2. Rotate the handle on the shaft to an upright
position; retighten wing nut.
NOTE:
Your unit is equipped with a special
accessory attached to the assist handle that
can store an extra replacement spool of line.
To store extra spool, push spool into accesso-
ry until it snaps into place. The spool can be
removed by firmly pulling on the tap button.
ATTACHING SHIELD
WARNING:
erly installed. The shield provides partial protec-
tion from the risk of thrown objects to the opera-
tor and others and is equipped with a line limiter
blade which cuts excess line to the proper
length. The line limiter blade (on underside of
shield) is sharp and can cut you.
For proper orientation of shield, see KNOW
YOUR TRIMMER illustration in OPERATION
section.
1. Remove wing nut from shield.
2. Insert bracket into slot as shown.
3. Pivot shield until bolt passes through hole in
bracket.
4. Securely tighten wing nut onto bolt.
5
When adjusting the assist
Tap Button
The shield must be prop-