Cleaning And Maintenance - Siemens SIMATIC RTLS Series Operating Instructions Manual

Installation & Operation

3.2 Cleaning and maintenance

Assembling the transponder prior to starting up
Proceed as follows to assemble the transponder prior to starting up:
1. Insert the battery in the battery compartment according to the polarity direction.
2. Close the housing by first placing the top part into the bottom housing and letting it
engage on the bottom.
Remove the battery before returning the device
Remove the battery before returning the device. Batteries must not be returned.
Battery change
Use approved batteries
Installation of non-approved or damaged batteries may result in damage to the device or its
surroundings. Only use batteries approved by the manufacturer, see section "Technical
specifications (Page 13)". Before inserting a battery, make sure that it is not damaged.
Proceed as follows to replace the battery in the transponder:
1. Open the housing at the designated recess on the left-hand side in an upwards direction
using a suitable tool.
2. Remove the battery to be replaced and wait 30 seconds before inserting the new battery
while maintaining the polarity direction.
3. Close the housing again until you hear it click into place.
3.2 Cleaning and maintenance
The enclosure may only be opened to change batteries.
The device may only be repaired or opened for other types of work by an authorized
maintenance company.
Improper opening or repairing of the device may result in risks for the user. Opening the
device without permission renders the warranty of the Siemens AG null and void.
Do not clean the enclosure with liquids or abrasive, caustic or flammable cleaning products.
12
CAUTION
CAUTION
Operating Instructions, 06/2020, C79000-G8976-C520-03
SIMATIC RTLS4030T