Information Display - Precor P82 Service Manual

SYSTEM SETTINGS
MENU
SUMMARY TIME
OUT
REGISTER
EQUIPMENT
MANAGE SETTINGS
Note: * not available on all models.

Information Display (65)

Service Access Code: 6, 5 (see
Information Display provides information about the equipment usage, hardware, software,
and error log data. . Select console model to view the available information and data.
Standard, P10, P20, & P30 consoles:
METRIC
ODOMETER
HOUR METER
BELT RATING
U-BOOT SW
LOWER SW
METRICS BOARD SW
SER NUMBER
USAGE LOG
P82 Console
Range: 1 to 120 sec
Default: 60 sec
Sets the time out to view the Workout Summary data.
Used to register the P80 after Connectivity interface has been con-
figured and established.
Used to save your equipment settings to a USB flash drive, or to
import settings from a USB flash drive.
"Service Access Codes" on
Displays the total number of accumulated miles on the unit.
This value is stored in the upper PCA in the console so if
the PCA is replaced the accumulated miles would start
again from "0".
Displays the total number of hours that the unit took to
accumulate unit miles.
This value is stored in the upper PCA in the console so if
that PCA is replaced the hours of use would start again
from "0".
Displays a belt rating from 10 (best) to 0 (worst). Reset-
table to 10 by holding QuickStart.
Displays the software part number and current version
installed in the upper PCA (console). This is the unit spe-
cific console software.
Displays the current version of software loaded in the
Machine Controller.
Displays the current version of software loaded in the met-
rics board.
Displays the model and serial number of the equipment.
The base serial number can be set here using the
WinCSAFE computer software. The factory default is
NONE.
Displays the type of workout programs the users are
accessing most frequently.
3 Standard Service Software
DESCRIPTION
page 20)
DESCRIPTION
Information Display (65)
26