Weed Eater 530084129 Instruction Manual page 7

TROUBLESHOOTING TABLE
WARNING:
Always stop unit and disconnect from the power source before
performing all of the recommended remedies below except remedies that re-
quire operation of the unit.
TROUBLE CAUSE
Semi-automatic
1. Crowding trimmer line
head stops against material being
under a load or cut.
does not turn 2. Electrical failure.
when switch is 3. Thrown circuit breaker.
pressed. 4. Debris stopping head.
Line does not 1. Line improperly routed
advance or in head.
breaks while
2. Line improperly
cutting. wound onto spool.
3. Incorrect line size
4. Not enough line
outside of head.
5. Dirt buildup on unit.
Line welds onto 1. Line size is incorrect.
2. Incorrect spool.
spool.
3. Line is being crowded
against material being
cut.
Line releases
1. Line improperly
continuously. routed in head.
2. Spool damaged.
Line usage is
1. Line improperly routed
excessive.
in head.
2. Line size is incorrect.
3. Crowding line against
material being cut.
4. Spool worn or damaged.
Line pulls back
1. Too little line outside
into head.
of head.
2. Line size incorrect.
REMEDY
1. Allow tip of line to do the cutting.
2. Contact your authorized service dealer.
3. Check Breaker Box.
4. Remove debris.
1. Check line routing.
2. Rewind line tightly and evenly.
3. Use only .065 in. (1.65mm) dia. line.
4. Remove cover and pull 4 in.
(10 cm) of line out of head.
5. Clean unit.
1. Use only .065 in. (1.65mm) dia. line.
2. Replace with correct spool.
3. Cut with tip of line fully extended.
1. Check line routing.
2. Replace spool.
1. Check line routing.
2. Replace spool.
3. Cut with tip of line fully extended.
4. Replace spool.
1. Remove cover and pull 4 in.
(10 cm) of line outside of head.
2. Use only .065 in. (1.65 mm) dia. line.
7