Hoover HWCB 15 UKBM User Manual page 27

Adjusting the height and levelling off your wine cabinet
HWCB 15 UKBM, HWCB 30 UKBM, HWCB 60D UKBM, HWCB 60DD UKBM
HWCB 15 UKSSM, HWCB 30 UKSSM, HWCB 60D UKSSM, HWCB 60DD UKSSM
o The appliance is equipped with adjustable feet, so that the height may
o We recommend that two people carry out this procedure.
o The height must be adjusted prior to building the appliance into the
housing unit and it should be set at such a height that the top panel of
be affected.
* Due to there is a nut on the bottom of the leg which is there for fixing the leg
firmly when you adjust to the max height of 880mm. In that case, if you want
to reduce the height further you can remove the backup nut( 6.5mm thick-
ness).
Fitting the plinth
1. Locate the plinth (packaged inside the appliance)
2. Remove the four screws from (two on each side of) the plinth
section, but take care to support both sections to prevent the
adjustable section from falling away. Remove the adjustable front
section and place this somewhere safe.
o Tilt the appliance approximately 60° to allow access
to the adjustable feet.
o Take care to ensure the cabinet is supported at all
times.
o Twist the foot into a suitable position to level the
cabinet.
o Repeat these steps for the other adjustable feet.