On/Off Switch - Weed Eater 545186751 Instruction Manual

Specifically marked as suitable for out-
D
door use. The cord must be marked with
the suffix "W".
Heavy enough to carry full current from
D
the power source to the unit. Otherwise,
loss of power and overheating can oc-
cur causing damage to unit. Refer to
table for minimum wire gauge recom-
mendations. The cord must be marked
with the proper wire gauge. (Appropri-
ate extension cords are available.) Do
not use multiple cords.
In good condition. Cord insulation must
D
be intact with no cracks or deterioration.
Plug connectors must be undamaged.
use multiple cords.
DO NOT
MINIMUM WIRE GAUGE
RECOMMENDATIONS
VOLTS 25 FT. 50 FT.
120 16 16
A.W.G.* A.W.G.*
*American Wire Gauge
KNOW YOUR ELECTRIC BLOWER/VACUUM
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
Compare the illustrations to your unit to familiarize yourself with the location of
UNIT.
the various controls and adjustments. Save this manual for future reference.

ON/OFF Switch

Cord
Retainer
Rear
Handle
Inlet Cover
Latch
Tube Release Button
Inlet Restrictor
ON/OFF SWITCH
The is used to activate
ON/OFF SWITCH
the motor.
Secure the extension cord to the unit by
threading the cord through the cord re-
tainer (see illustration). Insert the cord
receptacle into the recessed plug.
CAUTION: Failure to use cord retain-
er could result in damage to the unit,
extension cord, or both.
Cord
Receptacle
Cord
100 FT.
Retainer
14
A.W.G.*
USING YOUR UNIT
Top Handle
Air Vents
Upper Vacuum Tube
Retaining Post
Vacuum Assist Handle
Upper Vacuum Tube
Blower Tube
Lower Vacuum Tube
INLET COVER LATCH
The
INLET COVER LATCH
and close the inlet cover and to secure
the upper vacuum tube to the blower
unit.
7
Recessed
Plug
on Unit
Collection Bag
Elbow
Tube
is used to open