Removing The Packaging And Handling - Electrolux AOFP061U Manual

FIG.2
FIG.3
FIG.4
FIG.5
2
3
4
B.1.2.1 Removing the packaging and handling
Cut the straps and remove the protective film, taking care not to
scratch the sheet metal if scissors or blades are used. Remove
the cardboad top, the polystyrene corners and the vertical
protection pieces. For appliances with stainless-steel cabinets,
carefully remove the protective film without tearing it, to avoid
leaving glue stuck to the surface.
Should this happen, remove the traces of glue with a non-
corrosive solvent, rinsing it off and drying carefully. It is advisable
to go over all the stainless steel surfaces with a cloth coated with
vaseline oil, in order to form a protective film. Use a pallet-jack
or fork-lift truck to lift appliances. Inserting the forks under the
pallet, lift the appliance and carry it to the place of installation,
making sure that the load is balanced. Remove the equipment
from the wooden pallet, move it to one side, then slide it onto the
floor.
5
13
FIG.6
FIG.7
FIG.8
6
7
8