Installing Features - Weber Genesis Silver-C Owner's Manual

Install the right end trim piece with tool holders
and right swing-up work surface
You will need: Right trim piece with tool holders, right
swing-up work surface, swing-up work surface rod, one
1/2 inch bolt, one nylon washer and a wrench
1.) Start the right end trim piece into the frame as
shown, do not push the trim piece in all of the
way and do not add bolt yet.
2.) Slide the swing-up work surface rod through the
holes at the top of the swing-up work surface.
C090.a

Installing Features

(1)
3.) Insert one end of the swing-up work surface rod
into the hole in the frame.
C-1