Operation Procedure - Rheem Raypak RPVSP1 Installation And Operation Manual

Operation Procedure

Power Up
Plug in the power and the pump will perform self-diagnostic
checks.
• If there is error, it will display as shown below. Call
your installer or dealer to fix the problem.
Figure 8. Error
• Normal display is as shown below. Use the
buttons to adjust the speed (SP) in RPM.
Figure 9. Power
• Short press MODE again to display the power
consumption (P) in Watts.
• Short press MODE again to display the clock (CL).
Figure 10. Clock
Clock Setting
In order to have the schedule run properly, the clock must
be set at your local time.
CONTROLLED COPY approved for factory use on 4/16/2020. RAYPAK PROPRIETARY AND CONFIDENTIAL INFORMATION . Approva
1. Long press (press and hold for 2 seconds) the MODE
button to access clock settings.
2. Short press SPEED 1 and SPEED 2 to shift between
Hour and Minute. The applicable digits will flash.
3. Press or
4. Short press the MODE button to save setting or press
SPEED 3 to cancel.
5. The unit will then exit the clock setting mode.
Preset SPEED 1-3
There are three preset speed: press SPEED 1, SPEED 2
and SPEED 3 to change the pump speed.
or
Figure 11. SPEED 1 = 1500 RPM
Figure 12. SPEED 2 = 2400 RPM
Figure 13. SPEED 3 = 3400 RPM
to adjust the value.
11