Table of Contents
Advertisement
To add an MAV to a workgroup
Target MAV
3-3 Changing Settings
1
On the [MAV] menu, click [Add New MAV].
The Add New MAV dialog box appears.
2
Specify the appropriate information in the following text boxes.
[MAV Name]:
The on-screen name of the MAV. This name can be
composed of a maximum of 8 alphanumeric characters,
excluding spaces and tab marks.
[IP Address]:
The IP address of the MAV.
[GbE transfer]: To make Gigabit Ethernet transfers possible, select this
check box, and then specify the IP address of the computer
used for Gigabit Ethernet transfers connected to the MAV.
[Target]:
To select the MAV as the target MAV, select this check
box.
3
When you are done, click [OK].
The dialog box closes and the MAV is added to the workgroup.
It is possible to control any MAV on the network with this program, but only one
at a time. The MAV selected to be the subject to BZMA-E555 control is called
the "target MAV". When adding an MAV, if [Target] is selected in the Add New
MAV dialog box, that MAV becomes the target MAV. You can change target
MAV whenever necessary.
After finishing initial setup and starting to use the BZMA-E555, it is possible to
modify settings or add new MAV to a workgroup, for example. For details refer
to the BZMA-E555 User's Guide.
Refer to the User's Guide for details about the following:
• Adding MAV to a workgroup
• Modifying an MAV drive name
• Selecting a different target MAV
• Deleting an MAV from a workgroup
9
3-3 Changing Settings
Advertisement
Table of Contents
