Motorola MTM800 Product Information Manual page 255

GPS
The Status values configured in the ID column of this list must also be registered in the general list of
outgoing Status values.
30.18.1 Status Value List ID
This is the ID of the pre-configured Status value.
Type in the required value.
30.18.2 Enable Send Location Report
If enabled, a location report will be sent when the Status value (ID) is sent.
Turn the check box on (Enable) or off (Disable) by clicking in the check box.
30.18.3 High Accuracy Mode
Specifies the behaviour of the radio for the GPS accuracy mode in case of sending an outgoing
Status message via the user menu.
There are 3 possible choices:
• No Change - Radio keeps the current GPS accuracy mode
• Enter - Radio enters the GPS high accuracy mode (high power consumption)
• Leave - Radio leaves the GPS high accuracy mode and enters the normal accuracy mode
(low power consumption)
To select the option, put the pointer into the field value, click on the arrow, and drag the pointer to the
desired option.
30.18.4 High Accuracy Mode Timeout
Duration in seconds when High Accuracy Mode should be left after it has been entered due to a
Status message.
Type in the required value.
Related field:
High Accuracy Mode
The range for this setting is 0 - 56535 seconds, the default is 0 seconds.
September 2008
Chapter 3 - MTM800 Product Information Manual
3-141
6866537D87-F