Peel-Off Sensor Installation (Sold Separately) - Wasp WPL606 User Manual

3.4

Peel-off Sensor Installation (Sold Separately)

1. Turn the printer off
2. Open the lower front panel
3. Snap the peel-off sensor onto the bar that is under the print head pressure
adjustment knobs horizontally
Socket for Peel-off
sensor
4. Plug the Peel-off sensor into the socket by sliding it along the bar into the
socket
5. Close the panels and turn the printer back on
6. If you are printing from windows you must turn peel off mode on in the
Advanced Setup section of Printing Preferences for this printer
7. Go to section 4.2 Gap / Black Mark Detector Sensor Calibration and calibrate
the labels
Figure 12: Peel Sensor attached to bar
Figure 13: Peel Socket
Figure 14: Peel Sensor into Socket
10
Bar
Peel-off sensor