Wasp WPL606 User Manual page 12

6. Pull the paper core up to the rewind spindle and slide it on. Slide both the
ribbon and rewind spindle all the way to be flush with the case side of the
spindle. The Wasp logo will face up again
Flush with
Case
Figure 7: Ribbon placed onto Rewind Spindle
7. Roll the rewind spindle by hand until some of the actual ribbon shows in the
front of the printer. The Wasp logo will roll over the top of the spindle.
Ribbon in
front
Figure 8: Ribbon wound into printing position
8. The ribbon must route above the black ribbon sensor.
Figure 9: Ribbon Sensor and Ribon placement
Figure 6: Ribbon under Pint Had
8
Ribbon
Ribbon
Sensor