Advertisement
TROUBLESHOOTING
Scanner not working
No power to scanner
Incorrect interface
cable used
Check system power;
ensure power supply,
Ensure that correct
if required, is connected
interface cable is used
Scanner decoding bar code, but data not transmitting to host
Scanner not programmed for
correct host interface
Check scanner host parameters
or edit options
SCANNER PROGRAMMING BAR CODES
Reset Defaults
Set Postamble
Erase All Rules
1
2
Begin New Rules
Send All Data
3
BEEPER INDICATIONS
Standard Use
Low/medium/high beep
Short high beep
Power up
Parameter Menu Scanning
High/low/high/low beep
High/low beep
Successful parameter
setting
©2005 Wasp Technologies. All rights reserved.
Wasp reserves the right to make changes to any product to improve reliability, function, or design. Wasp does not assume any product liability arising out of, or in connection with, the
application or use of any product, circuit, or application described herein. No license is granted, either expressly or by implication, estoppel, or otherwise under any patent right or patent,
covering or relating to any combination, system, apparatus, machine, material, method, or process in which Wasp products might be used. An implied license exists only for equipment,
circuits, and subsystems contained in Wasp products. Wasp and the Wasp logo are registered trademarks of Wasp Technologies. Other product names mentioned in this manual may be
trademarks or registered trademarks of their respective companies and are hereby acknowledged.
w w w . w a s p b a r c o d e . c o m
Wasp Technologies, 1400 10th Street, Plano, TX 75074, www.waspbarcode.com
Interface/power
cables are loose
Check for loose
cableconnections
Interface cable is loose
Check for loose cable connections
Start Here if you have a USB scanner
USB Host Types
Enter
Choose a Postamble
4
Tab
If you do not need a Postamble scan
NOTE
4 long low beeps
Bar code decoded [if
Transmission error
decode beeper enabled]
detected; data is ignored
Low/high beep
Correct programming
Incorrect programming
sequence performed
sequence or Cancel bar
code scanned
Scanner not decoding bar code
Scanner not programmed
for bar code type
Ensure scanner is
programmed to read type
of bar code beingscanned
Scanned data incorrectly displayed on host
Scanner not programmed for correct host interface
Check scanner host parameters or edit options
Start Here if you have a keyboard wedge scanner
Keyboard Wedge Host Types
<Enter>
<Tab>
Erase All Rules only.
1
LED INDICATIONS
Off
Scanner is on and
ready to scan, or no
power to scanner
Green
Bar code is
successfully decoded
Red
Transmission error
QUICK START GUIDE
Bar code unreadable
Distance between
scanner and bar
Ensure bar code is not
code incorrect
defaced; try scanning
test bar code of same
Move scanner
bar code type
closer to or further
from bar code
5
Save All Rules
Advertisement
