Rover Side - Airlink101 Raven G3210 How To Use Manual

$PASHS,SPD,A,9
$PASHS,DSY,A,C<CR><LF> $PASHR,ACK
$PASHS,DSY,C,A<CR><LF> $PASHR,ACK
AT\APASSTHRU<CR><LF>
ATS0=1<CR><LF>
$PASHS,DSY,OFF<CR><LF> $PASHR,ACK
The CDMA/GSM modem base is initialized, and ready to be used by the rover.
2.2.2

Rover side

The Allegro terminal with FastSurvey shall be connected to Z-max either with Bluetooth
wireless link or serial cable to port A.
In Fast Survey utility you will find, a terminal utility that allow sending command to Z-max.
2.2.2.1 Dialing to the base
Commands to send with Allegro terminal connected to port B of Z-max
Command to send to Z-max
$PASHS,SPD,A,9
$PASHS,DSY,A,B<CR><LF> $PASHR,ACK
$PASHS,DSY,B,A<CR><LF> $PASHR,ACK
AT\APASSTHRU<CR><LF>
ATD Base Phone Number
$PASHS,DSY,OFF<CR><LF> $PASHR,ACK
Commands to send with Allegro terminal connected to Z-max through Bluetooth
Command to send to Z-max
$PASHS,SPD,A,9
$PASHS,DSY,A,C<CR><LF> $PASHR,ACK
$PASHS,DSY,C,A<CR><LF> $PASHR,ACK
AT\APASSTHRU<CR><LF>
ATD Base Phone Number
$PASHS,DSY,OFF<CR><LF> $PASHR,ACK
After a few seconds the rover is connected to the base, and receive data from the base
2.2.2.2 Hang-up the rover
Just disconnect the Airlink modem from its power source.
17/08/2007
$PASHR,ACK
OK
OK
Port A
Response from Z-max
$PASHR,ACK
OK
OK
Response from Z-max
$PASHR,ACK
OK
OK
3/ 21/
Set PortA in 115.2Kbps
Set Z-max in transparent mode
Set Z-max in transparent mode
Wait 30 seconds before continue
Set the number of ring before
connection
Remove the transparent mode
Serial cable
or
Bluetooth
Comments
Set PortA in 115.2Kbps
Set Z-max in transparent mode
Set Z-max in transparent mode
Wait 30 seconds before continue
Dial to the base phone number
Remove the transparent mode
Comments
Set PortA in 115.2Kbps
Set Z-max in transparent mode
Set Z-max in transparent mode
Wait 30 seconds before continue
Dial to the base phone number
Remove the transparent mode