Advertisement
ConneCting Power
and oPerating Blower
1. Check to make sure that the power cord is
completely clear of the blower wheel and that
there are no other foreign objects in blower
wheel. Also double check all wire leads and
make sure wire routing is not pinched or in a
precarious position. Correct accordingly.
CAUTION: Never touch the
blower wheel while in operation.
2. Turn on power to duplex outlet if previously
turned off per the warning on page 2.
3. Plug in blower power cord to duplex outlet
(see Figure 2, page 2).
4.
Turn blower on and check for
BK Model:
operation. Turn blower off by turning knob
fully counterclockwise before continuing.
Wiring Diagram Decal
12" in Front of Blower
(BKT Model Only)
108998-01E
Figure 10 - Location of Wiring Diagram Decal
(Model May Vary From Illustration)
Variable
Fan Switch
Off
110/115
V.A.C.
Black
Green
White
Figure 11 - Wiring Diagram
www.desatech.com
BKT Model:
speed control knob is in the ON position and
the thermal switch senses temperature after the
fireplace begins to heat up. The blower speed
can be adjusted by rotating the control knob.
To turn off, turn knob fully counterclockwise
until it clicks off. If the blower is ON and has
been running with the fireplace operating, the
blower will continue to run for a short time
after the fireplace has been turned off. As the
thermal switch cools down, the blower shuts
down automatically.
5. Peel off the backing paper and stick the sup-
plied wiring diagram decal on the firebox bot-
tom approximately 12" in front of the blower
(see Figure 10).
6. Replace all panels and/or brick bottom if
previously removed.
1
Black
2
On
The blower will only run when the
Fan Switch
(N.O.)
Blue
Red
Blower
Motor
7
Advertisement
