Page 2
Tel: 1-888-456-8468 (Monday-Friday: 9:00 – 17:00 PST) MANUFACTURER Manufacturer: Shenzhen NearbyExpress Technology Development Co.,Ltd. Address: Floor 7, Building E, Galaxy World Phase II, Shenzhen, China Learn more about the EU Declaration of Conformity: https://www.taotronics.com/pages/user-manual MODEL: TT-AH026 ULTRASONIC COOL MIST HUMIDIFIER 03-19-2020 User Manual TT-AH026_V1.6_EN...
Power On / Off and Mist Adjustment Low Water Protection: Auto Shut-off the Humidi er CLEANING AND MAINTENANCE Caution Daily Maintenance Weekly Maintenance Scale Removal Instructions 10/11 Disinfecting Instructions End-Of-Season Care and Storage TROUBLESHOOTING GUIDE 13/15 WARRANTY TAOTRONICS CUSTOMER CARE...
BEFORE USING THE HUMIDIFIER STATEMENT Thank you for purchasing a TaoTronics product that has been tested to meet our stringent quality standards. This product is covered with TaoTronics product and labor warranty for 12 months from the date of its original purchase.
WHEN USING THE HUMIDIFIER 1. DO NOT place the unit on carpet, towel or wood surface, which will block the vent and may damage the unit. 2. DO NOT place the humidi er near naked ames and heat sources, such as 1.
AFTER USING THE HUMIDIFIER PACKAGE CONTENTS · 1 x TaoTronics Humidi er (Model: TT-AH026) · 1 x Cleaning Brush · 1 x Thank You Card · 1 x User Manual 1. Always disconnect from a power source by pulling the plug when not in use.
OPERATIONS AND FUNCTIONS Add water 1. Turn the water tank upside down. Remove the tank cap and ll the tank with clean and cool water only. 2. Attach the tank cap and place the tank back onto the base. Please make sure it ts together securely so that water can go from the tank to the reservoir.
CLEANING AND MAINTENANCE Caution 1. DO NOT submerge the base in water. 2. Make sure water does not enter the base through the air outlet, air inlet, or the control knob. Power On / Off and Mist Adjustment 3. DO NOT wash any part of this humidi er in dish washer Plug the power cord into a wall socket.
Disinfecting Instructions 15-20 minutes 1. Follow steps 1-2 of the previous section on scale removal. 2. Fill the water tank half full. Add in ½ tsp of bleach. Place the tank cap back on. Swish the solution around in tank. Place the tank on the base. The bleach solution will enter and disinfect the water reservoir as well as the other components.
TROUBLESHOOTING GUIDE Not enough water Re ll and reinstall the inside the tank water tank Mist level is set too low Adjust to maximum mist 1. If the information listed in the troubleshooting guide can’t solve your The LED Indicator is problem, please email us for help.
WARRANTY 1. Adjust to maximum mist This product is covered with TaoTronics product and labor warranty for 12 Mist level is set too low 2. Close door or windows for the room size to reduce air ventilation, months from the date of its original purchase. You will be given a warranty...
Page 12
FCC Compliance This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. WEEE Compliance Correct Disposal of This Product (Waste Electrical &...