Required Tools - Cisco ciscoBus CSC-C2CTR Installation And Upgrade Instructions

Required Tools

You need some or all of the following tools to perform installation and upgrade procedures. Before
you begin, read through the procedure to determine which tools you need for your chassis.
•
Flat-blade screwdriver: medium-sized (if you are removing the AGS+ front access panel for the
first time).
•
Number 1 Phillips screwdriver (for removing the top cover of the chassis and installing the
applique, applique card cage, and ground strap).
•
Chip extraction/removal tool (for microcode upgrades only).
•
Needlenose pliers (for microcode upgrades only).
•
Antistatic mat or antistatic foam pad (only if you are replacing components).
•
Wrist strap or other grounding device. A disposable wrist strap is included with the card; use it
to prevent damage to equipment from electrostatic discharge.
Safety
Follow these guidelines when working with any electrical equipment:
•
Before beginning any procedures requiring access to the chassis interior, turn off the system
power and disconnect the power cord.
•
Never assume that power has been disconnected from a circuit; always check.
•
Do not work alone when a potentially hazardous condition exists.
•
Do not perform any action that creates a potential hazard or makes the equipment unsafe.
•
Carefully examine your work area for possible hazards such as moist floors, ungrounded wiring
or power cables, and missing safety grounds.
In addition, use the guidelines that follow when working with any equipment that is connected to
telephone wiring or other network cabling.
•
Never install telephone wiring during a lightning storm.
•
Never install telephone jacks in wet locations unless the jack is specifically designed for wet
locations.
•
Never touch uninsulated telephone wires or terminals unless the telephone line has been
disconnected at the network interface.
•
Use caution when installing or modifying telephone lines.
ciscoBus Token Ring Card and Applique Installation and Upgrade Instructions
Installation Prerequisites
17