Advertisement
6
Power Supply (24 VDC)
Power for the junction box (24 VDC) is supplied from the DCU (VR-7010). Use the DPYC-1.5 (local supply) to con-
nect between the J1 port on the junction box and J313 port on the DCU. For wiring the DCU, see the installation
manual of the VDR (IME-44850).
1.
Fabricate the DPYC-1.5 cable as shown below.
Armor
Vinyl tape (Width: 20 mm)
2.
Unfasten seven binding screws (M4×10) to remove the junction box cover.
3.
Pass the wires through the cable entrance, then connect them to the J1 port.
4.
Fix the cable to the cable clamp, using a cable tie (local supply).
Note: The armor of the cable should contact the cable clamp.
5.
Reattach the junction box cover.
Sheath
Sheath
80 mm
J1 port
J1 port
6 mm
0.5 to 1 mm
Crimp the rod terminals (AI1.5-6
BK, supplied), using the crimping
tool (CRIMPFOX 10S). After
crimping, confirm that the 0.5 to
1 mm of the wires are exposed.
Insert the wire while pushing the
opener.
Opener
Opener
Fix the cable to the cable
Fix the cable to the cable
clamp, using a cable tie.
clamp, using a cable tie.
6
Advertisement
