Table of Contents
Advertisement
English
2
16 mm
1
3
4
Engage the combination wrench (2)
N
on the hexagon (3) at the base of
the tine (1).
Use the combination wrench to
N
loosen the tine.
Unscrew the tine from the rake (4).
N
12
2
4
Screw the tine (1) into the rake (4)
N
as far as possible by hand.
Engage the combination wrench (2)
N
on the hexagon (3) at the base of
tine (1) and screw down as far as
stop.
Use the combination wrench (2) to
N
tighten down the tine (3) firmly by
turning it another 30° to 40°.
1
3
4
2
3
Fitting Protective Tube on Tine
If the optional set of protective tubes is to
be used, for part number see "Special
Accessories", fit them before mounting
the tines.
1
2
Position the tube (1) on the end of
N
the tine and push it part-way onto
the tine (2).
Stand the screw end of the tine (1)
N
on a suitable base and gradually
pull the tube (2) over the tine.
Fit the tube (2) so that the ends of
N
the tube and tine (1) are
approximately in line.
If you have difficulty fitting the protective
tubes, contact your local dealer for
assistance. STIHL recommends a
STIHL servicing dealer.
SP-KM
Advertisement
Table of Contents
