Bosch GlassVAC Solo Plus Original Instructions Manual page 10

10 | English
view of accessories can be found in our accessories pro-
gram.
Technical Data
Cordless Window Va-
cuum
Article number
Rated voltage
Rated capacity
Protection class
Weight according to
EPTA‑Procedure 01:2014
Permitted ambient temperature
– during charging
A)
– and operation
– during storage
Battery
Rated voltage
Capacity
Number of battery cells
A) The machine will not switch on at temperature below −5 °C.
Battery Charger (PSU)
Charging period (battery
discharged), charger ≥ 1
Amp
Use a 5V DC USB charging outlet with a min. 1amp out-
u
put, certified to IEC/EN 61558-2-16 and IEC/EN
62368-1.
Mounting and Operation
Action
Product features
Delivery scope
Charging the machine
Connecting/disconnecting the suction
A)
head
Filling the spray applicator bottle
Connecting the spray applicator head
Connecting the spray applicator head
A)
276 mm
Attaching the microfiber cloth 276
A)
mm
F 016 L81 880 | (16.10.2018)
GlassVAC
3 600 HB7 0..
V= 3.6
W 15
IP X4
kg 0.7
°C 0 ... +45
°C -5 ... +45
°C -20 ... +50
Li-Ion
V= 3.6
Ah 2.0
1
min 130
Figure Page
A 150
B 151
C 151
A)
D 152
A)
E 153
Action
Disconnecting the spray applicator
A)
head
Using the machine
A)
Using the spray applicator
Emptying the dirty water tank
Cleaning the machine
Cleaning the microfiber cloth
Accessories
A) Accessories
Initial Operation
Pay attention to the mains voltage. The voltage of the
u
power source must match the voltage specified on the
rating plate of the machine.
Note: The battery is supplied partially charged. To ensure
full capacity of the battery, completely charge the battery
before using your power tool for the first time.
The lithium-ion battery can be charged at any time without
reducing its service life. Interrupting the charging procedure
does not cause damage to the battery.
The battery is protected against deep discharging.
When the battery is discharged, the machine will stop.
Battery Charging (see figures A and B)
Note: The micro-USB port (16) for connection of the micro-
USB cable (15) is in the handle.
When the battery charge is low, the charger level indicator
(4) flashes green.
When the charger level indicator (4) flashes red, the battery
must be charged. Switch the machine off and charge the bat-
tery.
To charge the battery use only the USB cable (15) provided
and a certified battery charger. Plug the charger into the
socket. The charging process begins.
During the charging procedure, the handle of the machine
warms up. This is normal.
The charger level indicator (4) continuously lights up red
during the charging procedure. When the battery is fully
charged, the charger level indicator (4) continuously lights
up green.
Disconnect the battery charger from the mains supply when
charging process ends.
Observe the notes for disposal.
Figure Page
F - G 154 -
156
G 154 -
156
H - I 156 -
157
J 158
K 158
Bosch Power Tools