Table of Contents
Advertisement
Available languages
Available languages
T2QSG.fm Page 5 Tuesday, January 11, 2005 5:50 PM
3.
Charge the Battery
If the battery you installed is a disposable CP1 battery, you
can skip this step. If the battery you installed is a
rechargeable Lithium Ion battery, it will be partially charged.
To charge the battery:
1. Plug the power cord into the HP AC adapter. If more than
one power cord is in the box, use the cord that is
appropriate for power outlets in your country. Plug the
other end of the power cord into an electrical outlet.
2. Open the small rubber door on the side of the camera.
3. Attach the thin cord from the AC adapter to the power
adapter connector
shown. The Power/Memory light on the back of the
camera will start blinking to show that the battery is
charging.
When the Power/Memory light stops blinking, the battery is
fully charged, and you can then unplug the power adapter
from the camera. You can continue to use the camera while
the battery is being charged by the power adapter.
on the side of the camera as
5
Advertisement
Table of Contents
