Cdma Call Processing - Motorola V2260 Service Manual

CDMA 800/1900
on a Portable is RF coupled to the Test Sys-
tem. The phone is powered by a battery. All
of these tests are performed on a pass/fail
basis except where otherwise specified.
The following AMPS Call Processing tests
must be done in a single test sequence.
Step 1. Initialize: Set the RF Communication
Test System to provide an AMPS control
channel at -50 dBm on channel 334.
Step 2. AMPS Registration: Turn the mobile
transceiver on and force an AMPS Registra-
tion.
Step 3. AMPS Page: Page the mobile trans-
ceiver.
When the transceiver alert rings, answer the
call using the FLIP for a Portable, the SEND
key for a Mortable. Verify that the mobile
has transferred to the traffic channel
and is transponding SAT.
Step 4. AMPS Handoff: Initiate a handoff to
another AMPS traffic channel. Verify that
the mobile has handed off to the new traffic
channel and is transponding SAT. Terminate
the call using the FLIP for a Portable, the
END key for a Mortable. Verify that the
mobile has terminated the all and de-keyed
the transmitter.

CDMA Call Processing

The following CDMA Call Processing test
must be done in a single test sequence.
Step 1. Initialize: Configure the test system
to the following set parameters:
a. A CDMA pilot on channel 777 with sector
A power at -70 dBm and sector B power at
-80 dBm.
36
b. An AMP traffic channel with a 6 kHz tone
modulated at 2 kHz of deviation.
c. A CDMA traffic channel handoff message
set to the corresponding AMPS traffic chan-
nel frequency with SATcolor code 1 and
power attenuation code 3.
d. A CDMA System Parameters Message
with the following threshold data: Pilot
detection threshold
(T_Add) = 28 Pilot drop threshold (T_Drop)
= 32
Comparison threshold (T_Comp) = 5
Drop timer value (T_Tdrop) = 3
Step 2. CDMA Slotted Mode Page: Turn the
mobile transceiver on and force a CDMA
Registration. Page the mobile with a Service
Option 1 call. Verify that the mobile estab-
lishes and maintains a CDMA call by
measuring Rho.
Step 3. CDMA Softer Handoff: Set sector B
power to -75 dBm.
The mobile must report sector B as
included in the Candidate set. Increase sector
B power to -65 dBm. The mobile must report
sector B to be added to the Active set.
Initiate a softer handoff and decrease sector
B power to -80 dbm. The mobile must report
sector B to be dropped from the Active set.
Step 4. CDMA Hard Handoff: Perform a
CDM Hard handoff theo channel 691 while
still in a Service Option 1 call.
Verify that the mobile hands off and main-
tains the call by measuring Rho.
Step 5. CDMA to AMPS Handoff: To
perform a CDMA to AMPS handoff, send
the CDMA traffic channel handoff message
to the mobile transceiver and activate the
AMPS traffic channel. Verify that the mobile
4/3/01