Expression Pedal Control Initialization Settings - Vox Valvetronix ToneLab SE Owner's Manual

NOTE: Nothing will be controlled if the target effect is "OFF."
The expression pedal target is indicated as follows.
"*/###### *: Target category, ######: Target parameter
• Examples
"--OFF--" --- OFF
"VOLUME" ---
"P/DIRECT" --- (*: P (pedal))
"M/SPEED" --- (*: M (modulation)) SPEED of a modulation effect
"D/INPUT" --- (*: D (delay))
"R/MIX" --- (*: R (reverb))
"A/VRGN A" --- (*: A (amp))
In addition to the examples we've shown here, a wide variety of expression tar-
gets provided for each effect model can be freely assigned to the two expres-
sion pedals.
If desired, you can make more detailed settings.
NOTE: For "--OFF--", "VOLUME", "M/PITCH", "D/INPUT", and "R/INPUT", operat-
ing the expression pedal does not edit the parameter.
5. Turn value knob 2 to make the name display read "EXP 1 MIN." Here you can
specify the PITCH value for when the pedal is at the minimum position. Use
value knob 2 or the ▲, ▼ buttons to adjust the setting.
6. Turn value knob 3 to make the name display read "EXP 1 MAX." Here you can
specify the PITCH value for when the pedal is at the maximum position. Use
value knob 3 or the ▲, ▼ buttons to adjust the setting.
When you operate the expression pedal, the target parameter will change
within the range you specified here.
In the same way, you can use value knobs 4–6 or the ▲, ▼, √ √ √ √ , ® ® ® ® buttons to
make expression target parameter settings for expression pedal 2. (When you
are making EXP2 expression target settings, the value display indicates "E2.")
NOTE: When you change the expression target, the MIN and MAX values will be
initialized.
7. Press the EXIT switch to return to the mode you were in.
NOTE: The changes you make will not be preserved in internal memory unless you
store the program.
E
XPRESSION PEDAL CONTROL INITIALIZATION SETTINGS
"EXP1INIT" Expression pedal 1 initialization setting
"EXP2INIT" Expression pedal 2 initialization setting
If you press the ® ® ® ® button several times while the EXPRESSION button is
blinking, the "EXP1INIT" setting screen will appear.
If you then press the ® ® ® ® button again, the "EXP2INIT" setting screen will appear.
(control nothing)
Volume pedal
DIRECT (mix amount of original sound)
for a pedal effect (e.g., OCTAVE)
Input level of a delay effect
MIX (mix amount of reverb sound) of a
reverb effect
[VR GAIN] (channel A) of an amp model
55