TP-Link RE210 Quick Installation Manual page 2

To minimize wireless interference, place your Range Extender in an open
space area, away from other bluetooth devices or radioactive devices such
as cordless phone, microwave, etc.
Enjoy!
2
Using WPS (Wi-Fi Protected Setup)
Important: In order to use this option, your router must support WPS.
1 Power On
Plug the Range Extender into a wall outlet
close to your router, and wait until the Power
LED is lit and solid green.
3 Relocate
Refer to Step 5 of Option 1 to relocate your
Range Extender.
Enjoy!
Entertainment Adapter
The Range Extender RE210 can be used as a wireless
adapter to connect any Ethernet-enabled device,
such as a Blu-ray player, game console, DVR, or smart
TV, to your wireless network.
First, connect the Range Extender to your Wi-Fi
network following the instructions in Option 1 or
Option 2, then connect an Ethernet-enabled device
to the Range Extender using an Ethernet cable as
shown in the diagram on the right.
Troubleshooting and Support
My router has no WPS button, how do I connect
1
the Range Extender?
Your router does not support WPS, please use Option
1 to setup the Range Extender using a web browser.
Why does the WPS LED not change from blinking
2
to solid green after completing Option 1?
• You may have entered the wireless password of your
router incorrectly during the con guration. Please
login to the Extender's web management page, and
double-check your router's wireless password.
2 Connect
A. Press the WPS button on your router/AP.
Note: For more information about using WPS on your
router, please refer to the router manufacturer's user guide.
YourNetworkName
and password
The Range Extender shares the same wireless network name (SSID) and
wireless password as your router.
Ethernet Connection
Smart TV Game Console Desktop
• If the RE LED still keeps blinking, please reset the
Extender and go through the con guration
again.
What should I do when the WPS LED is on, but
3
only one band is connected?
It depends on your router capabilities, if either the
2.4G or 5G LED is not on while the Extender
connected to your router/network, press the WPS
button on the router and the Range Extender
again to connect the other band.
Keep away from
B. Immediately push the RE button on your Range
Extender.
If the RE LED does not switch from blinking to a solid
green, please refer to Option 1.
YourNetworkName
and password
5G
2.4G
Ideal Range Extender Placement
Wireless Connection
Laptop
What do I do if I cannot access the Extend-
4
er's web management page?
• Make sure your computer is connected to
the Extender's network.
• Change the computer's xed IP address to
Obtain an IP Address Automatically.
How do I restore the Range Extender to its
5
factory default settings?
While the Range Extender is plugged into a
power outlet, press the Reset button for 5
seconds until all the LEDs ash once.
The " " LED should change from
ashing to solid, showing that WPS
connection was successful.
Smartphone Tablet