Volvo V50 User Manual page 90

2006 Volvo V50
The following example explains how button 1 can be programmed. Buttons 2 and 3 can be programmed
in the same way.
To program (store) a seat position in button 1:
1. Use controls 5, 6, and 7 to adjust the seat to the desired position.
2. Press and hold down the M (memory) button.
3. With the M button depressed, press button 1 to store the seat's current position.
To move the seat to the position that it was in when button 1 was programmed, press and hold down
button 1 until the seat stops moving.
As a safety precaution, the seat will stop automatically if the button is released before the seat has
reached the preset position.
Central locking system remote control and driver's seat memory
The remote control transmitter can also be equipped with an optional function that controls the
electrically operated driver's seat in the following way:
1. Adjust the seat to the desired position.
2. When you leave the car, lock it using the remote control.
3. The next time the driver's door is unlocked with the same remote control and the driver's door is
opened, the
pg. 78 Front seats
driver's seat will automatically move to the position that it was in when the door was most recently
locked with that remote control.
WARNING!
Because the driver's seat can be adjusted with the ignition off, children should never be left
unattended in the car.
Movement of the seat can be STOPPED at any time by pressing any button on the power seat control
panel.
Do not adjust the seat while driving. The seat should be adjusted so that the brake pedal can be
depressed fully. In addition, position the seat as far rearward as comfort and control allow.
The seat rails on the floor must not be obstructed in any way when the seat is in motion.
file:///K|/ownersdocs/2006/2006_V50/06v50_05a.htm (4 of 15)12/30/2006 4:49:32 PM