Getting Help; Plug And Play; Auto Adjustment - Dell 1700 User Manual

1700FP-E.book Page 5 Monday, November 2, 1998 4:51 PM
8. Turn on your computer and monitor. If your monitor displays an image,
installation is complete.
9. Perform the auto adjustment procedure as described in "Auto Adjustment,"
below.

Getting Help

If your monitor does not display an image, check your cable connections and refer to "Trou-
bleshooting" on page 13. If you experience difficulties with the quality of the displayed
image, run auto adjustment again and refer to "Adjusting Your Monitor" on page 7 or "Trou-
bleshooting" on page 13.

Plug and Play

Our adoption of the new VESA
consuming setup. It allows you to install your monitor in a Plug and Play compatible system
without the usual hassles and confusion. Your PC system can easily identify and configure
itself for use with your display. This monitor automatically tells the PC system its Extended
Display Identification (EDID) data using Display Data Channel (DDC) protocols so the PC
system can automatically configure itself to use the flat panel display.

Auto Adjustment

Even though your computer system can recognize your new flat panel display system, the
auto adjustment function will optimize the display settings for use with your computer.
Auto Adjustment can be accessed through the On-Screen Menu, See "Image Lock:" on
page 10 or use the direct access instructions below:
1. Turn on your computer and monitor.
2. Push the EXIT button to open the Auto Adjustment OSM.
3. Push the + button to activate the Auto Adjustment function. The screen will
dim and you may notice small changes to the screen image.
To abort the Auto Adjustment function, press the EXIT button again.
4. When finished, the screen will stop changing. Press the EXIT button to leave
the OSM or allow the OSM to timeout and disappear automatically.
®
Plug and Play solution eliminates complicated and time
Dell
®
1700 Flat Panel Monitor User's Guide 1-5