Table of Contents
Advertisement
4
3
2
1
Figure 19
1. Blade bolt
2. Lock washer
3. Accelerator
Sharpening the Blade
File the top side of the blade to maintain its original
cutting angle (Fig. 20A) and inner cutting edge radius
(Fig. 20B).
1
153
Figure 20
1. Sharpen at this angle only
Note: The blade will remain balanced if you remove the
same amount of material from both cutting edges.
Balancing the Blade
1. Check the balance of the blade by placing the center
hole of the blade over a nail or a screwdriver shank
clamped horizontally in a vise (Fig. 21).
Figure 21
Note: You can also check the balance by using a
commercially manufactured blade balancer.
2. If either end of the blade rotates downward, file that
end (not the cutting edge or the end near the cutting
edge). The blade is properly balanced when neither
end drops.
5
1627
4. Blade
5. Blade driver
2
2. Maintain the original
radius here
1007
Installing the Blade
1. Install the blade onto the spindle and the blade driver
with the curved blade tips pointing toward the lawn
mower deck and the blade driver nesting in the recess
of the blade (Fig. 19).
2. Install the accelerator, the lock washer, and the blade
bolt (Fig. 19).
3. Tighten the blade bolt to 50 ft-lb (68 N m).
WARNING
POTENTIAL HAZARD
Operating the lawn mower without the
accelerator in place can cause the blade to flex,
bend, or break.
WHAT CAN HAPPEN
A broken blade could cause serious injury or
death to the operator or bystanders.
HOW TO AVOID THE HAZARD
Do not operate the lawn mower without the
accelerator.
Lubricating the Self-propel
Drive
1. Wipe the grease fittings on the rear wheel height
adjustment levers with a clean rag (Fig. 22).
1. Grease fitting
2. Install a grease gun onto each fitting in turn and gently
apply one or two pumps of #2 multi-purpose lithium
grease to each.
IMPORTANT: Excess grease may prevent the wheel
clutch operation from properly operating.
Adjusting the Self-propel Drive
Cable
If the top speed begins to slow down on the lawn mower,
adjust the self-propel drive cable.
17
1
Figure 22
276
Advertisement
Table of Contents
