Install Drive Shaft
1. Insert drive shaft spline (supplied in installation kit) into
blower coupler (Fig. 10).
2. Rotate shaft until splines line up.
Note: To aid in the rotation of drive shaft, insert screw
driver into universal joint.
3. Slide drive shaft coupler onto spline shaft until it clicks.
2
3
Figure 10
1. Drive shaft
2. Blower coupler
4. Plug wire harness into blower harness.
1
3. Spline shaft
12
Grease Blower
Before the Debris Blower is operated, it must be greased to
assure proper lubrication. Refer to Lubrication section of
manual. Failure to properly grease the unit will result in
premature failure of critical parts.