Table of Contents
Advertisement
On Sand Pro 5000/5020 – Mount top of receiver
bracket to frame with a 3/8–16 x 1.25" lg. capscrew, (2)
.40 I.D. x .81 O.D. flat washers, .625" lg. spacer and
locknut. Mount bottom of receiver bracket to frame
with a 1/2–13 x .875" lg. capscrew and (2) .56 I.D. x
1.063 O.D. flat washers. Position components as shown
in figure 7.
Note: Use .375" lg. spacers instead of .625 lg. spacers
when machine is equipped with matt rack.
Note: Rear wheel shown removed for clarity. Do not
remove rear wheel.
3
Figure 7
1. Receiver bracket
2. Left rear wheel motor
2. Slide a hitch onto each side of blower frame. Use
forward set of hitch mounting holes when mounting
blower on a Sand Pro 2020 or Sand Pro 3020 and rear
set of holes for a Sand Pro 5000/5020. Secure hitch to
blower frame with (4) 3/8–16 x 2" lg. capscrews, .40
I.D. x .69 O.D. flatwashers and (8) spacers. Spacers to
be positioned between frame and hitch on each side
(Fig. 8).
1
2
3. Spacer
11
2
3
1
6
Figure 8
1. Hitch
2. Blower frame
3. Spacer
4. Recommended holes
3. Lift blower and position hitch pins into slots on top of
receiver brackets on Sand Pro (Fig. 9).
3
1
2
Figure 9
1. Hitch pin
2. Receiver bracket
4. Secure each hitch to receiver bracket with a clevis pin
and hair pin cotter.
4
3
5
5. Use for Sand Pro
5000/5020
6. Use for Sand Pro
2020/3020
4
3. Clevis pin
4. Hairpin cotter
Advertisement
Table of Contents
