Toro Greensmaster 3250-D Operator's Manual
8- and 11-blade cutting units
Hide thumbs
Also See for Greensmaster 3250-D:
- Operator's manual (52 pages) ,
- Service manual (260 pages) ,
- Quick start manual (2 pages)
Related Manuals for Toro Greensmaster 3250-D
Summary of Contents for Toro Greensmaster 3250-D
- Page 1 Form No. 3325-838 ® 8- and 11-Blade Cutting Units Greensmaster ® 3250-D Model No. 04470—210000001 and Up Model No. 04471—210000001 and Up Operator’s Manual English (GB)
-
Page 2: Table Of Contents
Note: emphasizes general additional information, contact an Authorized Service information worthy of special attention. Dealer or Toro Customer Service and have the model and serial numbers of your product ready. Figure 1 illustrates the location of the model and serial Optional Equipment numbers on the product. -
Page 3: Adjustments
Adjustments Note: Determine the left and right sides of themachine from the normal operating position. After the cutting unit is unboxed, use the following procedures to assure the cutting unit is adjusted properly. 1. Check each end of the reel for grease. Grease should be visibly evident in the reel bearings. -
Page 4: Leveling The Front Roller To The Reel
to compensate for reel wear. Position 2: Standard position; use for most conditions. Leveling the Front Roller to the Height-of-cut range: 2.4mm–18.3mm Reel Bracket Frame 1. Position the cutting unit on a flat, level surface. Down 2. Position a 6 mm or thicker plate under the reel blades and against the front face of the bedknife. -
Page 5: Adjusting The Top Shield Height
Adjusting the Top Shield Height 1. Loosen the bolts and nuts securing the shield to each side plate. 2. Adjust the shield to the desired position and secure the fasteners 3. Repeat the procedure on the remaining cutting units and adjust the top bar. The shield can be raised for extreme wet Note: conditions. -
Page 6: Operation
The grease fitting locations and quantities are: Additional instructions and procedures on Note: • Reel bearings (2) (Fig. 6) backlapping are available in the TORO Sharpening • Front and rear rollers (2 ea.) (Fig. 6). Reel & Rotary Mowers Manual Form No. 80-300PT. Important...