Table of Contents
Advertisement
Move control.
Move control forward.
Move control
rearward.
Assembly
1. Loosen the handle knobs and lift the top handle half in
an arc until the handle halves are in line and nest
together (Fig. 1).
Note: Use care to prevent pinching or stretching the
cables.
2. Tighten the knobs securely.
3. Rotate the handle toward rear of the mower until it
snaps into the handle brackets (Fig. 1).
1
2
Figure 1
1. Knob
1679
2. Top handle half
Raise/lower control
bar.
Raise control bar.
Raise control bar.
Lower control bar.
Before Starting
Oil
Initially, the crankcase must be filled with 20 ounces
(0.6 liters) of SAE 30 oil; 10W-30 oil may be substituted
if SAE 30 is not available. Use any high quality detergent
oil having the American Petroleum Institute (API)
"service classification"—SF, SG, SH or SJ.
Before each use, ensure that the oil level is between the
FULL and ADD marks on the dipstick (Fig. 2). Add oil if
the level is low.
1. Position the mower on a level surface and clean
around the dipstick (Fig. 2).
2. Remove the dipstick by rotating the cap
counterclockwise 1/4 turn.
3. Wipe the dipstick clean.
4. Insert the dipstick into the filler neck and rotate the
cap clockwise 1/4 turn.
5. Remove the dipstick and check the level of the oil on
the side of the dipstick with the FULL and ADD marks
(Fig. 2).
7
Advertisement
Table of Contents
