Disconnecting The Core Processor From The Workman Vehicle - Toro ProCore Operator's Manual

Figure 21
1. Latch handle
2. Latch handle pin in the
unlocked position
• Lift up on the latch handle (Figure 22).
• Slowly drive the vehicle forward until the hitch
assembly locks into place (Figure 22).
Note: Lock the hitch assembly in the extended
position by moving the latch handle pin to the
forward (locked) position (Figure 21).
Figure 22
1. Latch handle
9. Operate the core processor and check the hydraulic
fluid level in the vehicle. Replenish as required.
3. Locked position
2. Hitch assembly
8
Disconnecting the Core
Processor from the Workman
Vehicle
No Parts Required
Procedure
1. Remove the storage pins from the rear hole position
(Figure 23).
2. Slowly lower the processor until it comes to rest on
the rear roller and tires. Install the storage pins in the
front hole position (Figure 23).
3. After the storage pins are installed, turn off the
tractor.
1. Storage pin
2. Front hole (Core processor
disconnected from tow
vehicle)
4. Disconnect the hydraulic hoses.
5. Remove the remote control from the vehicle.
6. Wind the hoses and cable onto the harness mount
for storage.
7. To retract the tow hitch, lift up on the latch handle
and slowly back up the vehicle until the hitch
assembly locks into place (Figure 22).
8. Lower the jack to the ground to stabilize the machine
Figure 24).
18
Figure 23
3. Rear hole (Core processor
connected to tow vehicle)