IVT FB-04 Instruction Manual page 9

Tool symbol:
By choosing this symbol you will get to a view, in all real life system parameters will be displayed in an overview. By
touching the diagram symbol the right side menu bar of this system parameter window you may switch into the diagram
window. Here you have to possibility to display the daily, monthly and yearly power volume by using the now available
calendar symbol in the menu bar. With the return arrow symbol you may return to the previous view.
Timer function:
After choosing the respective (DSW or MPPTplus
of the menu bar. With this an automatic turn on/turn off of the load output may be preselected in a time-dependent
manner. The time selection will be done in 30 minute steps using the graphic symbols on the right side of the menu bar.
USE WITH INVERTERS OF THE DSW SERIES
When using the remote control with inverters of the DSW Series, the following option for operation and adjustment are
available:
Figure 1: Basic menu DSW
In the basic menu the display shows a battery symbol, an inverter symbol and a bulb symbol. Underneath a diagram
displays the real time power on the inverter output related to the time factor.
The battery symbol informs you of the current battery status by displaying a full or an empty battery.
When this symbol is being touched, the current battery voltage will be shown. By activating the check symbol
you will return to the basic menu.
If the inverter symbol is being chosen, on the following operation screen (see figure 2) the deep discharge
protection threshold (DISCHARGE) can be adjusted by using the „+"and „-"buttons.
At a 12 V battery system the adjustment can be made within the range of 9 - 12 V in 0.1 V steps, while at a
24 V battery system the adjustment within the range of 18 - 24 V can be made in 0.2 V steps.
To return to the basic menu the return symbol must be used.
By activating the bulb symbol a window containing the output parameters of the inverter (OUTPUT) will be
opened. This includes the output voltage, the output current and the output power of the connected
alternating current consumer. Additionally this view contains an ON/OFF symbol, which allows the manual on/
off switching of the load output via remote control.
By activating the check symbol this view may be closed.
+
) in the base menu, the time function may be accessed on the right side
Time will be ignored by the device (NONE)
Define shut off time (OFF)
Define turn on time (ON)
Enter the desired time in steps of 30 minutes
Back top previous view (Return arrow symbol)
Figure 2: Setting deep discharge protection
9
Figure 3: System parameter