Assembly - NordicTrack Wasatch Uintah User Manual

ASSEMBLY

Assembly requires two persons. Place all parts of the bicycle in a cleared area and remove the packing materi-
als. Do not dispose of the packing materials until assembly is completed.
Assembly requires a 5mm hex key
wrench .
1. Place the bicycle so that the fork and the
rear wheel rest on the floor.
Turn the handlebar stem and the fork so that
the handlebar clamp points away from the
top tube of the frame.
2. Remove the two bolts, the two washers, and
the handlebar clamp from the handlebar
stem.
3. Orient the handlebar so that the reflector
and the brake levers face forward and the
shifters face upward. Tip: Make sure to ori-
ent the handlebar so that the cables are
not twisted around the handlebar stem.
Tip: Start both bolts before tightening
either of them. While a second person
holds the handlebar in a centered position,
attach the handlebar with the two bolts, the
two washers, and the handlebar clamp.
, a Phillips screwdriver
Handlebar
Stem
Clamp
Fork
Clamp
Washer
Bolts
Washer
Bolt
Handlebar
7
, and an adjustable
Top
Tube
Handlebar
Stem
Bolt
Clamp
Rear
Wheel