Battery Installation; Receiver Removal - Napoleon Oakville Series Installation Manual

3.7

battery installation

4 AA batteries must be installed into the receiver before the appliance can operate by battery backup. The re-
ceiver is located in the bottom right corner of the appliance (Fig. 3-4).
1. Remove the battery cover plate by pushing the two tabs that hold the cover in place.
2. Remove the 4 AA batteries in the battery holder and replace with new ones.
note:
Note the polarity of the batteries and insert as indicated on the cover (+/-).
3. Reinstall the cover plate.

3.7.1 receiver removal

1. Remote the right access panel from the side of the appliance.
2. Remove the 2 screws from the inside edge (Fig. 3-5) and swing the control door open.
note:
If your opening is too small, you may need to pull the appliance out slightly.
3. Remove the 2 screws holding the receiver in place.
4. Pull the receiver through the access hole and replace.
Fig. 3-4
finishing
note:
Ensure the 3 position slider switch
is in the "REMOTE" position (middle
position).
Fig. 3-5
W415-1799 / B / 06.11.19
EN
19