Functions - Breville No-Mess Waffle BWM520 Instruction Book

Functions

Before first use, remove and safely discard
any packing material, promotional
labels and tape from the waffle maker.
1. Wipe the waffle maker cooking
plates with a damp sponge or cloth.
Dry thoroughly and close the lid.
2. Place the waffle maker on a flat, dry surface.
Ensure there is a minimum distance of
4" (10cm) of space on all sides of the
waffle maker. Do not place anything
on top of the waffle maker.
3. Unwind the power cord completely
and insert the power plug into a
grounded 110/120V power outlet.
4. Turn the POWER | DARKNESS control dial
to the desired setting to preheat the waffle
maker. The POWER light will illuminate.
5. Use the POWER | DARKNESS control
dial to adjust the brownness of your waffle.
There are 7 darkness settings ranging from
1 (lightest) to MAX (darkest).
Rotate the dial clockwise to increase
the brownness or counterclockwise to
decrease it. When making your first waffle
we suggest using a middle setting.
6. Once the waffle maker has completed
preheating, three audible alerts will sound
and the READY light will illuminate.
NOTE
When using the waffle maker for the
first time you may notice a fine smoke
haze. This is caused by the initial
heating of some of the components
and is not a cause for concern.
6
7. Open the lid and pour approximately
½ cup of batter evenly on the center
of the waffle plate. The batter should
cover the peaks of the waffle plate.
8. Close the lid but keep the locking latch
open. As the cooking cycle progresses
the READY light will switch off.
9. At the end of the cooking cycle, three
audible alerts will sound and the READY
light will illuminate. Open the lid and
carefully remove your waffle.
NOTE
There can be slight variations between
cooking cycles. If your waffles are not
at your desired darkness, close the lid
and cook for an additional minute.
10. For the most consistent results, add the next
batch of batter immediately after removing
the cooked waffle and repeat steps 8
through 9.
NOTE
If the next batch of batter is not added
immediately after removing the
cooked waffle, close the lid and allow
the waffle maker to properly reheat
(the READY light will switch off and
then back on) before adding batter.
11. If you are not cooking any more
waffles, turn the POWER | DARKNESS
control dial to the OFF position.