Maintenance; Troubleshooting - Jonsered HT2258 Li Operator's Manual

WARNING: Read and understand the safety
chapter before you clean, repair or do
maintenance on the product.
Daily maintenance
• Remove the battery pack. Refer to the operating
instructions of the battery pack for correct

maintenance.

• Examine the nuts, screws and bolts.
• Examine the trigger for correct operation.
• Examine the power button for correct operation.
• Remove external unwanted material from the
product with a soft brush or dry cloth. Do not clean
with water, cleaning fluids, or solvents.
Problem Possible faults
The product The power is off.
does not start
No electrical contact between
the product and battery pack.
The battery pack is not charg-
ed.
The battery pack or product
are too hot.
The battery pack or product
are too cold.
Motor controller is too hot.
Blades do not Blades are blocked
move
Error codes
The error codes help you do troubleshooting on the
battery pack and/or the battery charger while it charges.
LED screen
LED 1 is red and LED 4 is
green, battery pack does not
charge or operate correctly in
product
LED 1 is red
668 - 002 - 13.06.2018
MAINTENANCE

TROUBLESHOOTING

Possible step
Start the power. See
Install the battery pack correctly. See
page 8 .
Charge the battery pack. See the operator's manual for the battery
pack.
Let the battery pack and product cool down before you start the
product.
Let the battery pack and product become warm before you start
the product.
Let the battery pack and product cool down for a minimum of 1
hour before you start the product.
Remove unwanted material
Possible faults Possible steps
Internal fuse is Speak to an approved service center.
blown
Irregular cell volt- Speak to an approved service center.
age
• Use a soft brush to remove unwanted material from
the air vents.
• Examine the product for missing, damaged, loose or
worn parts.
• Examine the product to make sure the moving parts
align and are safe for operation.
• Lubricate the blades to prevent corrosion. The
lubricant must not be poisonous or dangerous to
persons, animal or plants. Make sure that the
lubricant goes between the top and bottom blades.
• Attach the blade guard.
• Lock the product in an area that children and not
approved persons cannot access.
• If the product is damaged, speak to an approved
service center. Do not use a damaged product.
To start the motor on page 8 .
(Fig. 17 )
To install the battery pack on
9