B Lade Agitator Assembly - Vita-Mix T&G2 Blending Station Owner's Manual

B lade Agitator Assembly
32
24
16
8
4
Never use a blade assembly with loose, damaged or nicked components.
Retainer Nut Removal
• The retainer nut is easily removed using the Retainer Nut
Wrench. To order a Retainer Nut Wrench please call your
Vita-Mix distributor and ask for Item #15596.
• To remove, turn the container upside. Using the Retainer Nut
Wrench turn the wrench counterclockwise to loosen the nut.
Once loosened, remove by hand.
• To replace, position retainer nut on top of blade assembly
and hand tighten. Then, using the Retainer Nut Wrench,
tighten clockwise until it stops. If it is not tight enough, you
will notice increased container noise.
20
Blade Agitator Assembly. Use caution when handling the blade; it is
sharp. When inserting the blade assembly through the container
bottom, grip the blades with a soft cloth, align the flat sides of the blade
assembly with the flat sides of the container. Place the retainer nut
back on the inserted blade assembly and tighten clockwise. Do not
force. Do not attempt to disassemble blade assembly.
Drive Spline. Mates with drive socket on the motor base to turn the
blade. NOTE: Removing and replacing your container while the
coupling is still rotating will strip the drive spline "teeth". (This part is
NOT removable.)
Retainer Nut. Must be snug. Use the available retainer nut wrench
for best results. (Refer to the diagram below to remove or replace.)
Retainer Nut Wrench