Complete The Finished Wall; Clean-Up After Installation - Kohler K-1109 Installation Manual

8. Complete the Finished Wall

- If you have not already done so, carefully remove the protective tape from the whirlpool rim.
- If necessary allow for deck mounted valves and spout.
- Cover the framing with water-resistant wall material. Seal the joints between the whirlpool rim edge and the
water-resistant wall material with silicone sealant.
- Tape and mud the water-resistant wall material. Install the finished wall to the water-resistant wall material. Seal
the joints between the whirlpool rim and the finished wall material with silicone sealant.
- Install the faucet trim according to the instructions packed with the trim.

9. Clean-Up After Installation

- When cleaning up after installation, do not use abrasive cleansers, as they may scratch and dull the whirlpool
surface. Use warm water and a liquid detergent to clean the surface.
- Remove stubborn stains, paint, or tar with turpentine or paint thinner. Do not allow cleaners containing
petroleum distillates to remain in contact with any whirlpool surfaces for long periods of time. Remove plaster
by carefully scraping with a wood edge. Do not use metal scrapers, wire brushes, or other metal tools. Use a
powder-type detergent on a damp cloth to provide mild abrasive action to any residual plaster.
Kohler Co.
Finished Wall Material
Apply silicone sealant to the
edges of the water-resistant
wall material and the finished
wall
Water-Resistant
Wall Material
Framing
Whirlpool
9
C
1010997-2-