Cut The Pump Banding Straps; Install The Plumbing - Kohler K-1109 Installation Manual

Drainage

4. Cut the Pump Banding Straps

IMPORTANT! This step is necessary to make your Kohler whirlpool operate more quietly.
- Use tin snips to cut the two pump banding straps from the whirlpool pump.
- To minimize whirlpool noise and vibration, be sure the pump is not in direct contact with the whirlpool harness
after the pump banding straps are cut.

5. Install the Plumbing

CAUTION: Risk of property damage. Ensure a watertight seal on the whirlpool drain.
- Connect the drain to the trap according to the drain manufacturer's instructions.
NOTICE: An access panel will simplify future maintenance.
- Install the faucet valving according to the faucet manufacturer's instructions. Do not install the faucet trim until
instructed. Open the hot and cold water supplies, and check the supply connections for leakage.
- Run water into the whirlpool, and check the drain connections for leakage.
Kohler Co.
Pump
Suction Line
7
Leave the pump support board
attached to the whirlpool.
Cut the pump
banding straps
Pump Support Bracket
C
1010997-2-