Data Cables - Vision Fitness T9300 Assembly Manual

2
STEP
2
STEP
3
STEP
3
STEP
6
BLUE BAG
• Mount the console to the console
mast using four bolts (M8 x 15L) and
tighten with the 5mm Allen wrench.
NOTE: Push all extra data cable into
the console mast. Make sure not to
pinch or cut the data cable.
• Mount the right-hand side mount
handlebar to the console mast using
two bolts (M8 x 135L). Repeat this on
the left-hand side.

DATA CABLES

MODELS T9200, T9300, T9500HRT,
T9600HRT & T9600HRT Comfort:
Plug in the small data cable into the
small plug connection on the lower
control board. Plug in the large data
cable into the large plug connection
on the lower control board.
MODELS T9700S, T9700HRT &
T9700 Runner: Plug the large 20-
ribbon cable into the
connection on the lower control
board. Slide down the rubber covers
on the left & right console supports.
• Install the motor cover making sure
that the rubber covers are inserted into
the motor cover. Secure the motor
cover using the six (M4 x 12L) screws
(see Yellow bag).
20-pin